I then needed to take this to the upholsterer (Jobsons at Dutton Park) who has done work for me previously. I also need to have the starter motor engagement cog replaced & a new sign made for the engine. Both of the companies that I had used before were no longer at the address I previously went to, so that was a bit of a bummer! I will have to try & find them. I also tried Repco & Bursons for a water temperature sensor & the water fitting from the manifold but no success at either place. Not a very successful shopping trip!
Tuesday, 19 November 2013
Capri - Restoration (2) White 1972 1600 XL [14]
Due to other
household tasks, there was not a lot of time spent on the car today. One of the
things to do on my list was to have the instrument pod recovered as the vinyl
has been badly cracked for a few years. It was one section that I did not get
done originally. It didn’t take too long once you lower the steering column
& remove the ignition cover on top of the steering column. There are three
other screws & one nut to undo & then you can slide out the instrument
panel. The speedo cable came out with a bit
of fiddling & then the whole lot comes out. I undid the four screws holding
the instruments to the pod & then after holding up the heater controls, the
pod comes away.
I then needed to take this to the upholsterer (Jobsons at Dutton Park) who has done work for me previously. I also need to have the starter motor engagement cog replaced & a new sign made for the engine. Both of the companies that I had used before were no longer at the address I previously went to, so that was a bit of a bummer! I will have to try & find them. I also tried Repco & Bursons for a water temperature sensor & the water fitting from the manifold but no success at either place. Not a very successful shopping trip!
I then needed to take this to the upholsterer (Jobsons at Dutton Park) who has done work for me previously. I also need to have the starter motor engagement cog replaced & a new sign made for the engine. Both of the companies that I had used before were no longer at the address I previously went to, so that was a bit of a bummer! I will have to try & find them. I also tried Repco & Bursons for a water temperature sensor & the water fitting from the manifold but no success at either place. Not a very successful shopping trip!
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment