Today was not
a good day. In fact, I had the axe & sledge hammer out ready to do the
Capri harm but as my back was so painful, I don’t think I could have done much damage
I started out very keen and assembled the engine crane ready for the job & decided where I was going
to place the car. I have limited head room under my house & I wanted to be
able to garage other cars as well as work on the white one.
Everything was going well until I tried to undo the drive/flex plate nuts. Firstly,
they can only be accessed through the starter motor hole, one bolt at a time,
with no room for a socket but a ring spanner is OK. Secondly, they are really,
really tight! Bloody tight, in fact! So tight that I couldn’t undo them. They
are not in a great place and lying on your back trying to undo them, only helps
the physio! The bolt is shown in the pictures below.

Time for some internet research – very useful for any restoration project. The
first thing I realised was that I was not alone in having trouble trying to
undo these nuts. I have gained a few tips which I will try when my back regains
some good feeling! Secondly, I can take the torque converter out with the
engine if one takes it carefully. That maybe is the way it comes out but I will
give those nuts one more go with a great deal of RP7 & perhaps a little
heat. I also tried to buy an extra-long ring spanner but with no success.
So after a couple of days recovery, I will give it another shot & I hope I
can get the motor out to start working on it. It is all fun! I forgot how much
fun it really is lying on your back, getting oil & green water all over
you.
For many
months I have been contemplating doing a major renovation of the white Capri.
It is 10 years since I had it repainted and did all the work on it. In that
time I have never done any serious work on the engine. Many bit & pieces
have been replaced or sorted such as the Webber carbie & various electrical
components but I have never done anything to the internals of the engine. It
has always been reliable, never holding me up, but is a bit of a slug.
Several other
things need some work e.g. the engine bay needs a good tidy up, the front left
hand strut needs a good work over, a few very small rust spots have appeared on
the right rear guard, the instrument pod cover needs recovering and the
headlights need replacement (reflectors are rusted).
So, today was
the day (10 October 2013) & I actually started. I am a reluctant starter at times as I know
these things take time & it could be several weeks before the car is back
in one piece. I asked my good neighbour, KH, to help me remove the bonnet &
to do an engine compression test, just to see if my concerns were justified.
The bonnet came off really quickly but it really takes two people otherwise
paint will be damaged. The compression readings were not very good: No 1
cylinder – 120; 2 – 80; 3 – 50; 4 – 80. This in itself suggests a makeover is
warranted. I think that when I did the same test on the green 1600, the lowest
reading was 100 with the others being around 120. So, it will be interesting to
see what condition the internals are really in and it explains why it is a bit
of a slug.
I have developed
a list of things to be done in this renovation:
1. Engine reconditioning
(valves & rings, fit electronic ignition)
2. Repaint & clean up
engine bay
3. LHS front strut bumper
stop
4. Bonnet rubber stops
& rod holder clip
5. Bonnet under dash
release handle
6. Remove rust spots on
RHS rear guard
7. Replace front
headlights
8. Recover instrument pod
9. Replace front seat
belts with inertia belts
10. Replace window felts
11. Renew chrome wheel
nuts
When these have
all been completed, the car should be in really good condition for another 40
years. I will also document progress on this little project.


